En bref

Printing for Electronics

HES-SO

Lorenzo Pirrami
Répertoire des compétences

janvier 2018 - août 2019

In this project, we investigate a new assembly process that consists in producing passive RFID tags only with printing steps.

In this project, we investigate, through theoretical models and experimental tests, the feasibility of a new assembly process that consists in producing passive RFID tags only with printing steps.

In this new process, a dielectric droplet encapsulated RFID chip is deposited, in correspondence of the binding site (contact) of the antenna, using a Drop-on-Demand (DoD)- based method.

The RFID chip is made up of a large metal layer (covering the entire surface) on the top of the chip. The latter acts as one contact and the bulk of the silicon die as the second contact. This leads to a capacitive coupling between the RFID chip and the antenna, in fact, the dielectric droplet forms both the mechanical and the electrical interconnection between the RFID chip and the antenna.

Using this approach, the RFID chip preparation (such as UBM and conductive bump deposition) is not required. In addition, the orientation of the chip inside the dielectric droplet can be arbitrary and the complex attachment (used nowadays with flip chip bonding process) of the chip with demanding temperature, pressure and alignment requirements are not necessary anymore.